Hi Guys and Girls.
I seem to have a problem getting Candy2o to flow properly.
I have followed the Hard Surface Apllication Guide allowing for the fact that it is only a guide rather than a set in stone rule book. I mix the Candy with between 25% to 50% 4030, then reduce. Usually the flow is intermittent, so I reduce some more and I have had some success running it through my Eclipse with a .35 setup around 25 psi. But even then it’s only if I have the needle back a good way and am throwing a lot of paint. That’s fine if I just want to cover something, but let’s say I wanted to paint an iris that is only part of an image I can’t seem to be able to control it much at all.
I’m straining the mix as it goes into the cup, tried different pressures too. Am I missing something?
Thanks in advance.
I seem to have a problem getting Candy2o to flow properly.
I have followed the Hard Surface Apllication Guide allowing for the fact that it is only a guide rather than a set in stone rule book. I mix the Candy with between 25% to 50% 4030, then reduce. Usually the flow is intermittent, so I reduce some more and I have had some success running it through my Eclipse with a .35 setup around 25 psi. But even then it’s only if I have the needle back a good way and am throwing a lot of paint. That’s fine if I just want to cover something, but let’s say I wanted to paint an iris that is only part of an image I can’t seem to be able to control it much at all.
I’m straining the mix as it goes into the cup, tried different pressures too. Am I missing something?
Thanks in advance.