For Every Airbrush Artist!

Ready to get involved? Register for free and you won't see any google advertising!

Register

snapped fitting

Discussion in 'Troubleshooting!' started by Lonekimono, Aug 10, 2017.


  1. Lonekimono

    Lonekimono Young Tutorling

    Joined:
    Apr 6, 2017
    Messages:
    28
    Likes Received:
    14
    Trophy Points:
    1
    Any suggestions on how to remove a fitting that snapped inside my compressor? The fitting broke off of my pressure gauge the piece is stuck inside where I would put a new fitting on. hope this makes sense.
  2. Lt4-396

    Lt4-396 Gravity Guru

    Joined:
    Apr 3, 2017
    Messages:
    386
    Likes Received:
    190
    Trophy Points:
    41
    Location:
    NYC
    Use a easy out or depending how loose it is a left hand drill.

    If it's not tight you can sometimes wedge a piece of wood in there and slowly turn it.

    If you can post a picture it would help show exactly what's going on.
    markjthomson likes this.
  3. markjthomson

    markjthomson Very happy! Staff Member Mod

    Joined:
    Jul 16, 2014
    Messages:
    6,086
    Likes Received:
    5,069
    Trophy Points:
    126
    Location:
    Auckland New Zealand
    Yup - pics help this one...

Share This Page