Not sure about teflon, but I've let a nozzle soak for about a week (Swapped it out and forgot about it), to come back and find it covered in oxidation.
I soaked a VLS body for 24 hours in it and the AB works fine.
I just cut a small piece of Teflon and put it in Restorer. I'll warm it to 130 degrees F for 24 hours and post here tomorrow.
After (over) 24 hours in the Restorer, there was no damage to the teflon chip I cut, in fact the shine was still on the chip from the razor where I cut it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.