Air brush holder from scrapps

[bentoad]

I dropped myairbrush that was in the “J “hook holder that comes with the brushes. I caughtthe hose with my foot pulling it from the “j” hook. I bent the needle. Seat antnose cone. An expensive mistake. 30 Min. later I had them hanging in this woodholder I made out of a scrap of 2x4 and a 1x4. It might not be pretty but you won’tpull it down any time soon.

I used a shortpiece of 2x4 for the main holder the length can be as long as he number of brushesit will hold .I drilled some 1 inch holes ¾ in deep then I ran it through my tablesaw cutting he groove wide enough forthe handle but stopping ay the cup holder. I then lowered the blade and cut outthe rest for the nozzle. Tested it for fit then glued and nailed a 1x4 to theback for a support that can be nailed to the wall. These pics are the way I cutthem.bentoad

 

[ad fez]

good idea bruce, nicely thought out.... serves the purpose well.... good job!

 

[Mr.Micron]

Good looking hold Bruce.

 

[Strictly Attitude]

looks nice Bruce I think you made a holder that really hols those AB's in secure also

 

[bentoad]

It ain't prety but it is cheap. Wasn't much thought . I went from cursing at the damage to on the wall in 30 min.

 

[worldofglasscraft]

I think I will copy this idea.

 

[bentoad]

No one sees it but you so it doesn't need to look finished.

 

[jgny1]

I see something else that could be airbrushed...LOL