M
maybach
Guest
I'm using the createx airbrush paint, and have reduced it with water just to test out. I feel like I'm getting the "milk" mixture right but at times feel like it is not spray enough of my opaque white color, and when I get close to do a line it comes out wet and does that spider looking effect as if it's over reduced, I finally realized to start lowering the PSI from 50 to 40 and trying to go lower. On an airbrush tip 0.3 mm.
What is the usually goo PSI to try to work with, with reduced paint?
What is the usually goo PSI to try to work with, with reduced paint?