is this main lever compatible with custom micron?

[redcore]

hey guys. i bought this lever from internet shop (they haven't had it online, no pics nothing. i just have been told that there is taller lever for custom micron and i got this - photo bellow). the thing is that i have absolutely no clue how to put it together. i have done some research on net and this lever is for other iwata guns :-/ but what means "cm" on the package then? custom micron? or do i need another compatible valve too?
rob

 

[AndreZA]

I doubt it is compatible. That looks like an Eclipse's trigger but I've seen similar ones that was used by Coast as an upgrade. It was normally a taller trigger then.

 

[wmlepage]

It says CM, so it might be micron compatible, but you would need to remove the pin under the existing micron trigger. No need to replace the air valve.

 

[Mr.Micron]

Yes you just need to remove both pieces of the trigger the Micron comes with.
But if it is not the taller trigger you will lose some of the response time that the two piece trigger gives you.

 

[ad fez]

my micron cmc+ has a horizontal bar on bottom of trigger pin that sits in a cradle to depress the air valve.... if im thinking along right lines this certainly wouldnt fit mine??

 

[Mr.Micron]

my micron cmc+ has a horizontal bar on bottom of trigger pin that sits in a cradle to depress the air valve.... if im thinking along right lines this certainly wouldnt fit mine??

It will fit. I thought the same thing but was proven wrong.

 

[ad fez]

No that can't be right micron..... I'm never wrong. ...I thoughti was wrong once. ...... But I was mistaken ;0)

 

[Mr.Micron]

No that can't be right micron..... I'm never wrong. ...I thoughti was wrong once. ...... But I was mistaken ;0)

hey you are just good looking but you are always wrong...

 

[shadow2462]

I know the discussion is about Iwata triggers, but that is the same trigger that is in my Master G23..... but of course Master is cloned from Iwata. go figure!

 

[redcore]

my micron cmc+ has a horizontal bar on bottom of trigger pin that sits in a cradle to depress the air valve.... if im thinking along right lines this certainly wouldnt fit mine??

since i have cmc+ too i have the very same trigger with that horizontal bar. thats why i couldnt understand how that taller trigger (because it really is taller thus more suitable for me) can fit cmc+. apparently i have to take out the valve and take some piece(s) out of it.
thanks guys!


Sent from my iPhone using Tapatalk

 

[AndreZA]

since i have cmc+ too i have the very same trigger with that horizontal bar. thats why i couldnt understand how that taller trigger (because it really is taller thus more suitable for me) can fit cmc+. apparently i have to take out the valve and take some piece(s) out of it.
thanks guys!


Sent from my iPhone using Tapatalk

You remove the piston from the top.

 

[redcore]

You remove the piston from the top.

hmm. have to figure out how. i have been cleaning that gun hundreds of times and it never came out.


Sent from my iPhone using Tapatalk

 

[Mr.Micron]

hmm. have to figure out how. i have been cleaning that gun hundreds of times and it never came out.


Sent from my iPhone using Tapatalk

Hold the airbrush upside down on a large piece of paper towel and give it s good tap it does not just fall out.
It is a royal paint to reinstall if you ever want too.

 

[redcore]

confirmed..it does work. i took out the piston and that taller trigger fits perfectly! thanks