Make your own onboard nozzle/needle cap holder

AndreZA

Air-Valve Autobot!
All you need is hot glue, a tooth pick and some lube. I'm using a Custom Micron which has a hole in the back already. The toothpick fits nice and snug.


Trim the ends off to make them square.
01.jpg


Don't make it too long inside as it can obstruct the needle movement. Outside it needs to be just as long as the needle/nozzle cap.
02.jpg


The next step happens quick and there was no time to take photos.


First All you do is put some lube on the inside of the thread of the cap. Then a small blob of hot glue on the toothpick. Quickly mold it with you hand into shape and screw the cap on.


You then have this.
03.jpg
04.jpg


Wait for it to harden and remove everything.
05.jpg


Trim off all excess glue.
06.jpg


Looks good.
07.jpg


An you are all done.
08.jpg
 
I once read a book called 101 things to do with Duct Tape, I think you should do a hot glue version.
 
Back
Top