E
EDGECRUSHER
Guest
my brush has been sitting a long time and for some insane reason it was allowed to sit with a film on it after cleaning. I actually started yelling because I assumed some troll had snuck into my shop and used it.
anyway, after further cleaning, sadly the air valve is sticking bad enough that it doesn't come up with my finger. Someone have a favorite solvent/lubricant or procedure for cleaning this hard to get at part without tearing it up? It's an Iwata HP-CS (Eclipse). (P.S. I had to yank hard on the needle to free it, hoping the seal is ok)
anyway, after further cleaning, sadly the air valve is sticking bad enough that it doesn't come up with my finger. Someone have a favorite solvent/lubricant or procedure for cleaning this hard to get at part without tearing it up? It's an Iwata HP-CS (Eclipse). (P.S. I had to yank hard on the needle to free it, hoping the seal is ok)